Johnson Service Bulletin SB-1175 - Adaptor Gasket 312837

Issued in November 1968, this bulletin warns dealers to inspect replacement V-4 adaptor gaskets for an incorrect dimension that could permit water to enter the engine.

Johnson Motors Service Bulletin letterhead

November, 1968

SUBJECT:   #312837 ADAPTOR GASKET - OUT-OF-PRINT

ON MODELS:   ALL V-4 MODELS

Factory photograph of adaptor gasket showing the 2 1/2 inch illustrated dimension

The subject gasket, although not used in production on all V-4 motors, is currently a production part and is used for service replacement on all V-4's through 1968 except the GT model.

We recently discovered the dimension as illustrated was approximately 9/64" out of print. All #312837 Gaskets in your service stock should be checked for the correct dimension, 2-1/32".

If you find any out of print, they should be scrapped immediately. The use of an "out-of-print" gasket may very well be the cause of water in any one or all of the cylinders. Water vapor can be drawn from the exhaust stack into the driveshaft cavity and then through the lower crankshaft bearing.

Since this gasket is first assembled to the underside of the Adaptor plate by installing the water tubes and the inner exhaust tube, it is understandable that when the adaptor plate, tubes and gasket are assembled to the exhaust housing, a mismatch of gasket to mating surfaces could go unnoticed.

JOHNSON MOTORS

Carl Klawonn
Administrative Assistant

CK:rkm

NOTE:   Post on your V-4 Indexes under the heading "Lower Unit."