Johnson Service Bulletin SB-1179 - Tachometer Usage

Issued February 1969 for 1969 55, 85 and 115 HP models. The bulletin documents factory tachometer configurations and the wiring changes needed to use alternate OMC tachometers.

Johnson Motors Service Bulletin factory letterhead

February, 1969

SUBJECT:   TACHOMETER USAGE

ON MODELS: 55ES(L)69, 85ESL69 & 115ESL69

As produced, the 85 & 115 horsepower engines are wired for the new OMC, Alternator Tachometer. This tachometer, P/N 172254 (Ring Bezel) or P/N 172258 (Sun Shielded), is activated by pulses from the engine alternator rather than from the ignition system. As a result, a more accurate and reliable solid state electronic circuit is obtained. Also, should the tachometer fail for some reason, the ignition system will not be jeopardized.

Shown in Figure 1 is a drawing of the terminal block on the 85ESL69 and 115ESL69 as viewed from the back of the motor. This drawing will assist you in following the rewiring instructions below.

Figure 1 - numbered terminal block 1 through 12

FIGURE 1

There may be occasions when you will need to utilize either the OMC Universal Tachometer or the special OMC Breakerless C.D. Tachometer. To do so, a simple circuit change can be made at the engine terminal board.

Instructions for rewiring an 85ESL69 for OMC Universal Tachometer:

1.Disconnect GRAY lead from terminal #7.
2.Remove GRAY lead from terminal #4 and replace screw.
3.Remove two (2) BLUE leads from terminal #5 and relocate on terminal #7.
4.Attach the two (2) loose GRAY leads to terminal #5.

NOTE: The switching around of wires is necessary because of lead lengths.

PAGE 2        SERVICE BULLETIN SB-1179
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085

Instructions for rewiring 115ESL69 for OMC Breakerless C.D. Tachometer:

1.Remove GRAY lead from terminal #3 and replace screw.
2.Attach GRAY lead removed in step 1 to terminal #5.

The OMC Accessory brochure states the New OMC Alternator Tachometer can be used on 55, 85 & 115 horsepower models, 1969 thru . . .

To use this tachometer on the 55 horsepower, a wiring change will be required since the 55 horsepower is factory wired for ignition pulse tachometers.

Instructions for rewiring 55ES(L)69 for OMC Alternator Tachometer:

1.Remove the GRAY lead from the three-way connector, engine harness side as shown in Figure 2.
2.Splice the above lead into one of the YELLOW stator leads in the adjacent three-way connector. This splice should be done on the engine harness side.
3.If the YELLOW stator lead was removed for the above splicing, be sure it is securely reinstalled in the connector housing.
Figure 2 - original Johnson photograph identifying gray and yellow wiring leads

FIGURE 2

Be sure to recoat the terminal board with liquid neoprene when removing any wires. The liquid neoprene is available in pint cans from your Parts Distributor, as follows:

LIQUID NEOPRENE - PART NO. 315417 - $3.25 net

JOHNSON MOTORS

D. J. Cankar
Administrative Assistant

DJC:rkm

NOTE: Post on your Miscellaneous Index under "Accessories."

Historical reference

SB-1179 documents wiring changes for the 1969 OMC alternator, universal and breakerless C.D. tachometers. Specifications and wiring procedures above are reproduced for historical reference from the original Johnson factory bulletin.