Johnson Service Bulletin SB-1181 - Faulty Power Tilt Operation

March 1969. Johnson advised dealers that inadequate battery-to-power-tilt wiring could prevent the tilt motor from raising 33 through 115 H.P. outboards. The bulletin recommends 10 AWG wire and identifies two power cable kits.

Johnson Motors Service Bulletin factory letterhead

March, 1969

SUBJECT:FAULTY POWER TILT OPERATION
ON MODELS:33 THROUGH 115 H.P.

Several reports have been received regarding the inability of the power tilt unit to raise the motor.

Investigation of the problem indicated that in many instances too small a diameter wire had been used between the battery and the red connection of the power tilt cable at the dash. This resulted in the tilt motor receiving insufficient power to produce proper operating pressure.

To assure proper voltage to the tilt motor, the wire size should be 10 AWG. We recommend including either of the following power cable kits with each power tilt installation:

Outboard Power Cable Kit ------- 172191
Forward Power Cable Kit
(includes ammeter) ------------ 172194

JOHNSON MOTORS

Doug Cankar

Administrative Assistant

NOTE:  Post on your 33 through 115 horsepower Indexes under the heading "Miscellaneous."

Historical parts reference

172191 - Outboard Power Cable Kit. 172194 - Forward Power Cable Kit (includes ammeter). The factory specified 10 AWG wiring for the power tilt battery connection.