Johnson Service Bulletin SB-1182 - New Flywheel Timing Marks

Issued March 1969 for Johnson 55, 85 and 115 HP engines. Explains the revised timing marks on common flywheels and the procedure for certain early 1969 85 HP engines.

Johnson Motors Service Bulletin factory letterhead

March, 1969

SUBJECT: NEW FLYWHEEL TIMING MARKS

ON MODELS: 1969 - 55, 85 and 115 H.P.

When checking the timing of the 1969 V4 and 3 cylinder engines, you will notice that there are now two timing marks on the flywheel. The second set of timing marks are required for the 1969 models. Leaving the old timing marks on the flywheel allows us to use a common flywheel for several years.

When setting the timing on a 1969 V4, use timing mark "B". When setting the timing on the 1969 3 cylinder engine, use timing mark "A". If you should use one of these flywheels for service on a 1968 V4, use timing mark "A", as shown in Figure 1.

Factory photograph identifying timing marks on flywheel
FIGURE 1

Very early 1969 85 horsepower engines have only one timing mark on the flywheel. Should you have one of these engines, set the timing to the single timing mark just like on the 1968 models. With the throttle fully advanced, check the alignment marks on the distributor cap and distributor base. See Figure 2. If these two marks are aligned, the single flywheel timing mark can be used.

PAGE 2     SERVICE BULLETIN   SB-1182
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085

If these marks do not align, you will have to stamp a new timing mark on the flywheel 5/8" counterclockwise from the original mark and retime to this mark. (NOTE: When using this stamped mark or the cast in "B" mark, the distributor cap and base marks will not be aligned. This is normal.)

Factory photograph of distributor cap and base alignment marks
FIGURE 2
JOHNSON MOTORS

Doug Cankar
Administrative Assistant

DC:rkm

NOTE: Post on your 55, 85 and 115 H.P. Indexes under the heading "Ignition."

Historical service reference

SB-1182 (March 1969): New flywheel timing marks for Johnson 55, 85 and 115 HP engines. Timing mark A is used on the 1969 three-cylinder and service applications for 1968 V4 engines; timing mark B is used on 1969 V4 engines. Early 1969 85 HP engines may require an additional mark 5/8 inch counterclockwise from the original.