Johnson Service Bulletin SB-1183: Recoil Starter Failures

Issued March 1969 for Johnson 20R69 and 25R69 outboards, this bulletin describes two casting-related conditions that can cause recoil starter springs to disengage: interference at the K-O pin and flashing around its base.

Johnson Motors Service Bulletin gray factory letterhead

March, 1969

SUBJECT:   RECOIL STARTER FAILURES

ON MODELS:  20R69, 25R69

Factory starter comparison photograph with arrows marking the K-O pin and interfering casting bump

We have received several reports from the field of starter spring failure on the above model motors.

Failure of the starter spring is caused by two possible problems. We recently discovered that if the K-O pin is misadjusted when die cast, it leaves a bump, as illustrated. This bump can interfere with the pin, which in turn will cause the spring to come off the pin. This condition can be corrected by grinding the bump down to where it will not hit the pin.

Failure of the starter spring has also been attributed to flashing around the base of the pin, as illustrated. This causes the spring to ride high on the pin and eventually come completely off. It is important that the flashing be removed around the pin.

JOHNSON MOTORS

Doug Cankar
Administrative Assistant