Johnson Service Bulletin SB-1190 (April 1969)

This bulletin explains how to correct improperly drilled upper spring retainers on 1969 Johnson 9½ HP outboards. The original factory photograph shows the specified 11/64-inch hole.

Johnson Motors Service Bulletin factory letterhead

April, 1969

SUBJECT:  REDRILLING OF THE UPPER SPRING RETAINER, P/N 314586
ON MODEL:  1969, 9½ H.P.
Factory photograph of upper spring retainer showing redrill to 11/64-inch diameter

There is a very strong possibility that there are many of the subject upper spring retainers in the field that are improperly drilled.

The hole in the retainer is critical since it is the squareness of this hole with the axis that keeps the retainer in the center of the spool and sleeve.

If the upper spring retainer lays to one side of the spool and sleeve, it is conceivable that the hole in the retainer is off. In the event that you happen to have any retainers that are off, you should drill an 11/64" diameter hole through the retainer, as shown in the photo.

JOHNSON MOTORS

Doug Cankar
Administrative Assistant

DC:rm

NOTE:  Post on your MQ - 9½ H.P. Index under the heading "Miscellaneous."

Historical parts reference

314586 - Upper spring retainer, 1969 Johnson 9½ HP MQ series. Factory correction specifies redrilling an improperly aligned retainer to 11/64-inch diameter.