
June, 1969
SUBJECT: HIGH SPEED ORIFICE - P/N 316102
ON MODEL: 115ESL69(E) & (S)
A field reported lean carburetion condition on the subject engines has been traced to deformed high speed orifices. It has been found that the pilot portion of a driver used to install the orifices in the float chambers was bottoming on the face of the orifice, staking it and thus restricting the fuel flow through the orifice.

FIGURE 1
Figure one illustrates what the face of one of these damaged orifices looks like and figure two illustrates what a normal one looks like.
The serial number of the first engine to be built on which we know that this condition has been corrected is 115ESL69E, J3044730.
Any 115 that is slow to accelerate, falters on acceleration or is suspected to be low in top r.p.m. should have its orifices checked for the above mentioned condition.
A quick check for the 316102 orifice, which is stamped #62B, is to see if a 0.062" diameter drill shank will easily pass through it. If it will, the orifice is ok; if it will not, the orifice should be replaced.
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085

FIGURE 2
CAUTION:
Do not attempt to substitute #62 P/N 314087 orifices with #62B P/N 316102 orifices.
Doug Cankar
Administrative Assistant
DC:rm
NOTE: Post on your 115 H.P. Index under the heading "Carburetion."