Johnson Service Bulletin SB-1197 - Removal of Burr on Propeller Shaft

Issued June 1969 for 1968 55 HP and 1969 55, 85, and 115 HP outboards. Johnson cautioned that a burr on the propeller shaft could damage the seal assembly during reinstallation.

Johnson Motors Service Bulletin letterhead

June, 1969

SUBJECT:REMOVAL OF BURR ON PROPELLER SHAFT

ON MODELS:1968 - 55 H.P.
1969 - 55 H.P., 85 H.P. & 115 H.P.

Factory photograph of propeller shaft with arrow labeled REMOVE BURR

If the situation should arise where the removal of the propeller shaft is necessary, be sure to check the propeller shaft for a possible Burr as shown in the photo.

It is imperative that this Burr be removed with the use of a fine grit stone (hone) before re-installing the propeller shaft. If this Burr is not removed, it will cause damage to the seal assembly.

JOHNSON MOTORS
Doug Cankar
Doug Cankar
Administrative Assistant

DC:rm

NOTE:  Post on your 55 H.P., 85 H.P. and 115 H.P. Indexes under
       the heading "Lower Unit."

Historical service note

The factory photograph marks the location of the burr. Johnson instructed technicians to remove it with a fine grit honing stone before reinstalling the propeller shaft to avoid damaging the seal assembly.