Johnson Service Bulletin SB-1200 - Use of Test Tank Water Adapters

Issued July 1969, this bulletin cautions against running 55, 85 and 115 HP outboard motors out of water using test tank water adapters, and announces test propeller part number 384199 for 115 HP engines.

Johnson Motors Service Bulletin letterhead

July, 1969

SUBJECT:USE OF TEST TANK WATER ADAPTERS
ON MODELS:55, 85 and 115 H.P.

The test tank water adapters (commonly referred to as flushettes) available for the subject engines should only be used when running these engines in a test tank for additional cooling.

Running the subject engines out of water with the adapter as an only source of cooling water will cause devastating effects to the propeller shaft bearing housing bearings and seal. Also, if the engine is equipped with propeller, the propeller rubber hub will be damaged.

Water required for exhaust cooling is picked up through holes in the trim tab and is not part of the engine cooling system. Therefore, do not run the subject engines out of water with tank adapters.

Please note - Test propeller P/N 384199 is now available for the 115 H.P. motor at a net price of $21.75. Send order with prepayment to OMC GALESBURG, ILLINOIS.

JOHNSON MOTORS
J. R. Penland
Service Promotion Manager

JRP:rm

NOTE: Post on your 55, 85 and 115 H.P. Indexes under the heading "Miscellaneous".

Historical service and parts reference

Models: 55, 85 and 115 HP Johnson outboards. Test propeller: P/N 384199, intended for 115 HP engines. Original listed net price: $21.75 (July 1969).

The warning distinguishes test-tank supplemental cooling from the exhaust cooling water normally picked up at the trim tab. This historical bulletin is reproduced for archival reference.