Johnson Service Bulletin SB-1202 (July 1969). Factory instructions for reducing exhaust gas temperature and addressing propeller hub cooling problems on selected 55, 85 and 115 H.P. outboards.
Johnson Motors Service Bulletin letterhead

July, 1969 SB-#1202

SUBJECT:LOWERING EXITING EXHAUST GAS TEMPERATURE
ON MODELS:TR-10, 55ES(L)69, 85ES(L)69, 115ES(L)69
Figure 1 - 55 H.P. inner exhaust housing, angled 1/8-inch hole approximately 1 inch from bottomFigure 2 - 85 and 115 H.P. inner exhaust housing, 1/8-inch hole

Whenever one of the above motors is used on a slow moving boat such as a house boat or a boat with a high transom, we recommend the following changes be made when running into a propeller hub cooling problem. If for some reason the gearcase on one of the subject motors is removed, also make the change.

To remedy the situation on the 55 H.P. motor, it is necessary to drill a 1/8" hole through the front side of the inner exhaust housing approximately 1" from the bottom of the housing as shown in Figure 1. This can easily be accomplished by removing the gearcase and drilling at an angle from the inside of the inner exhaust housing.

On the 85 H.P. and 115 H.P. motors, it is necessary to drill a 1/8" hole in the approximate middle of the area on the inner exhaust housing as shown in Figure 2. This also can be easily done by removing the gearcase and drilling from the inside. Make sure when doing this to just drill through inner exhaust housing on all three model motors.

PAGE 2      SERVICE BULLETIN    SB-#1202
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085

On any 85 H.P. motors built prior to serial number 3036287, this correction is required.

On the 115 H.P. motors, any engine built prior to serial number 3046075, this correction is required.

On all 1968 and 1969 55 H.P. motors, this correction is required.

JOHNSON MOTORS Doug Cankar Administrative Assistant

DC:rm

NOTE:  Post on your 55 H.P., 85 H.P. and 115 H.P. Indexes under the heading "Lower Unit".

Archive notes: The diagrams and original drilling locations are reproduced from the factory bulletin. The factory instructions should be read in full before any service work.