September 1969. Johnson introduced a press-fit upper mount screw for 1970 55 and 60 H.P. engines and recommended installing it during service of earlier 55 H.P. motors.

Johnson Motors Service Bulletin factory letterhead

September, 1969

SUBJECT:   UPPER MOUNT CHANGE

ON MODELS:  TR(L)-10, 55ES(L)69, 60ES(L)70

Factory photograph of upper mount screw 316324, washers 313546 and 313580, and mount support

Beginning with the 1970 models, a new upper mount screw will be used.  This screw (P/N 316324) is a press fit in the mount and will not turn when the nut is removed or installed.  This feature eliminates the need for removing the powerhead when servicing steering bracket or swivel bracket parts.

These new mount screws will fit on 1968-1969 55 horsepower engines.  We recommend that these new screws be installed any time one of these engines is in for service which requires powerhead removal.  Since this screw is a press fit, it must be preassembled into the mount before the mount is attached to the adaptor.  During the pressing operation, the screw must be pressed into rear of mount, and mount must be supported on its inner diameter.  See illustration.

Any 60 horsepower engine built after serial number 3305917 will have the new upper mount change.

JOHNSON MOTORS
Doug Cankar
Doug Cankar
Administrative Assistant

DC:rkm

NOTE:  Post on your TR(L)-10, 55 H.P., 55ES(L) and 60ES(L) Indexes under the heading "Lower Unit".

Historical parts reference

Upper mount screw: 316324. Washers shown in the original illustration: 313546 and 313580. The bulletin identifies serial number 3305917 as the 60 H.P. production changeover threshold.

Factory bulletin reproduced for historical service research. Verify applications against the appropriate parts catalog before performing repairs.