Johnson Service Bulletin SB-1204 - Fixed Jet Screwdriver Modification

Issued June 1969, this factory bulletin specifies two handle alterations to fixed high-speed jet screwdriver 379664 to improve access to carburetors on 1969 Johnson 85 and 115 HP engines.

Johnson Motors Service Bulletin letterhead

June, 1969 SB-#1204

SUBJECT:MODIFICATION TO FIXED JET SCREWDRIVER - P/N 379664

ON MODELS:  1969 - 85 and 115 H.P.

Factory screwdriver drawing showing 1 1/4 inch removed from handle end and 1/2 inch removed near shaft

In order to remove the carburetor fixed high speed jets on the models indicated, with the subject fixed jet screwdriver, part number 379664, the screwdriver must be modified as follows to the dimensions indicated.

So that the screwdriver will clear the lower motor cover, when servicing the lower carburetor, 1¼" must be removed from the end of the handle (see illustration).

The handle must be further modified by removing ½" of the plastic handle at the shaft end (see illustration). This modification is necessary so that the screwdriver handle will clear the fuel pump mounting bracket when servicing the port side fixed jet on the upper carburetor.

It takes five minutes to make this modification with a hacksaw - Do it now. Don't wait until you are out in the middle of the lake on a service call to find out that you shouldn't have put it off until later.

JOHNSON MOTORS

J. R. Penland
Service Promotion Manager

NOTE:  Post on your 85 and 115 H.P. Indexes under the heading "Carburetion".

JRP:rm

Historical service tool reference

379664 - Johnson fixed high-speed jet screwdriver. The factory modification removes 1¼ inches from the handle end and ½ inch of plastic at the shaft end. Applies to 1969 85 HP and 115 HP carburetor service.