Johnson Service Bulletin SB-1207

September 1969. Johnson explained how to correct a potentially grounded gray tachometer lead in early 1970 hydro-electric remote controls, part 384022. A short could reduce alternator output by approximately half.

Johnson Motors Service Bulletin gray letterhead

September, 1969

SUBJECT:   HYDRO ELECTRIC REMOTE CONTROL - P/N 384022

ON MODELS:  1970 - 60 H.P., 85 H.P. and 115 H.P.

Figure 1, gray tachometer lead, black ground lead and clamp 316245 before correctionFigure 2, correct routing of gray tachometer lead and clamp 316245

Early production 1970 hydro electric remote control, P/N 384022, could possibly have the gray tachometer lead shorted to ground inside the box. If the gray tachometer wire is shorted to ground, it will result in approximately half output from the alternator.

Before installing a control in a boat, remove one half of the control making sure the gray tachometer wire is not installed under the clamp. If the wire is installed under the clamp, remove it and tape it as shown in Figure 1, making sure the end of the gray tachometer lead is looped over before taping. Before reassembling the control box, assemble the clamp, P/N 316245, upside down as shown in Figure 2; or, opposite of what is shown in Figure 1.

PAGE 2      SERVICE BULLETIN SB-1207
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085

This will improve the clearance between the wiring and throttle control casing guide. Also, make sure the gray tachometer lead is positioned as shown in Figure 2 to prevent it from interfering with any of the movable parts.

Any 60 horsepower engines built after serial number J3305316; 85 horsepower, serial number J3327289; and 115 horsepower, serial number J3339413 will have the changes described in this bulletin.

JOHNSON MOTORS

Doug Cankar
Administrative Assistant

DC:rm

NOTE:  Post on your 60 H.P., 85 H.P. and 115 H.P. Indexes under the heading "Electrical".

Historical service reference

Remote control: P/N 384022. Clamp: P/N 316245. The gray tachometer lead must be insulated and routed clear of the clamp and moving control components. The factory identifies the serial-number changeovers as J3305316 (60 H.P.), J3327289 (85 H.P.) and J3339413 (115 H.P.).