Johnson Service Bulletin SB-989A - Slow Speed Needle Adjustment

December 4, 1963. Simplified slow speed needle adjustment procedure for 90 HP carburetors, supplementing SB-989.

Johnson Motors gray Service Bulletin letterhead
SB-#989A
File after #SB-989
December 4, 1963
SUBJECT: SLOW SPEED NEEDLE ADJUSTMENT - 90 HP CARBURETOR
Service Bulletin #SB-989 dated October 22, 1963, described in detail what was con- sidered as correct procedure for adjusting the slow speed needles on a 90 H.P. carburetor. However, we have found that slow speed needle adjustment can be much simplified from the procedure originally offered in Bulletin SB-989.
Almost all 90 HP Engines will run satisfactorily on an initial slow speed jet adjust- ment of 1/2 turn out, plus quadrant adjustment as mentioned below. Here, in deviation from previous procedure, we no longer attempt to tune the engine by ear thru in- dividual needle adjustment. After making the initial adjustment, merely re-install all four plastic needle knobs after the quadrant has been positioned in the middle adjustment detent.
Figure 1 - 90 HP carburetor quadrant and middle adjustment detent
At this point the engine can be started. After the engine has reached normal operating temperature, final adjustment can be made with the quadrant that moves all four needles at once. By placing the quadrant (Fig. 1) in the center detent position before re-installing the needle knobs as mentioned in the previous paragraph, an equal amount of adjustment can be effected in either direction on all four needles, thus over- coming richness or leanness in the slow speed carburetor system. Final adjustment should be made with the engine turning at idle speed, or 600 RPM. Also - check for proper mixture during acceleration and adjust slightly if necessary.
There may be an isolated case, however, where the procedure mentioned above will prove to be ineffective. In this instance, refer back to the procedure for adjusting slow speed needles as outlined in SB-989.
Figure 1
JOHNSON MOTORS Robert Compton Administrative Assistant
RC:eb
NOTE: Post on your V4-90 HP Index under the heading "CARBURETOR".