Johnson SB-995 - Revised Steering Connector Kits

Issued December 3, 1963, this Johnson service bulletin announces revised steering connector kits for 28 through 75 HP outboards. It illustrates the change from a spring-loaded knob to a bolt, nut, washer, and stainless spacer washer, and explains correct spacer orientation during installation.

Johnson Motors Service Bulletin header
SB-#995
File after SB-#994
December 3, 1963
SUBJECT: Revised Steering Connector Kits
ON ENGINES: 28 thru 75 H.P. Models
Revised steering connector kits, Part No. 379568 for single engine and part numbers
378386 and 378387 for dual engines, are now available.
Factory Figure 1, revised steering connector kitFactory Figure 2, revised steering connector kitFactory Figure 3, revised steering connector kit
Figure 1
Figure 2
These kits utilize a bolt, nut, washer, and a 5/32" thick stainless spacer washer, as
illustrated, (figure 1) rather than the spring loaded knob incorporated in connector
377440 for 5 through 18 HP models (figure 2).
Figure 3
When installing the connector,
always be sure to position the
spacer, as shown in figure 3,
before tightening the attaching
bolt or damage to the carrying
handle will result. Note that
the center of the bracket is
assembled facing the engine rather
than outward as is done with
377440 kits.
Some of the early kits utilizing
the bolt and nut were packed with-
out the spacer washer, part No.
310967. If you have any of these
in stock, contact the Johnson
Service Department and a spacer
will be furnished.
JOHNSON MOTORS
Robert Compton
Administrative Assistant
RC:eb
NOTE: Post on your Miscellaneous Index under the heading "ACCESSORIES".

Historical parts reference

Single-engine connector kit 379568; dual-engine connector kits 378386 and 378387; earlier connector 377440; stainless spacer washer 310967. The factory instructs dealers to contact Johnson Service Department for a missing spacer in early kits.

Factory filing instruction: file after SB-994.