Johnson Service Bulletin SB-998 - Water Spray Drawn Through Lower Motor Cover

January 27, 1964. Two-page factory procedure for plugging five drain holes in the lower motor cover of 90 HP V4M(L)-10S engines.

Johnson Motors gray Service Bulletin letterhead
SB-#998
January 27, 1964
SUBJECT: WATER SPRAY DRAWN THRU HOLES IN LOWER MOTOR COVER.
ON ENGINES: 90 HP, MODELS V4M(L)-10S.
Reports have been received advising that water spray is being drawn thru the five small drain holes in the lower motor cover on 90 HP engines. Since these holes serve only to drain water from inside the lower cover after the engine passes a wash cycle in production prior to painting, they can be plugged without affecting performance. Drain holes to be plugged are identified by arrows one through five in Fig. 1.
A change will be processed shortly on production engines to correct this condition, eliminating two of these drain holes and re-locating the other three. Steps are also being taken to plug the three re-located holes with nylon buttons after the engine passes thru the pre-painting wash cycle.
The problem mentioned above can be corrected as follows on any 90 HP engine made prior to the change mentioned in the previous paragraph.
Original Johnson SB-998 factory photograph Figure 1Original Johnson SB-998 factory photograph Figure 2
Fig. 1
Fig. 2
1. Enlarge the five holes shown in Fig. 1 with a 1/4" drill - from underside of lower motor cover (Fig. 2).
Over
PAGE 2 SERVICE BULLETIN SB-998
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085
2. Install one piece of No. 203290 bumper in each hole (5 pcs. required). Start bumpers into holes from underside of cover to point where bumper can be grasped from top side with plier (Fig. 3), and pulled securely into position.
3. Use air nozzle to blow away aluminum chips that have collected in lower motor cover during drilling operation. This is important as chips could later be drawn into motor thru carburetor during motor operation.
Original Johnson SB-998 factory photograph Figure 3
Fig. 3
Part No. 203290 bumper is a standard service item. Order this item from your Parts Distributor.
Sincerely,
JOHNSON MOTORS Robert Compton Administrative Assistant
RC:eb