
October 20, 1964
SUBJECT: PART NO. 380608 TRANSOM PLATE KIT.
FOR ENGINES: MODELS YEAR HORSEPOWER RATING
JW-19A & 20 1964-65 3
JH-19A & 20 1964-65 3
The subject kit (Fig. 1) has just been made available for use with 3 HP
engines which have the single clamp screw type stern bracket. It will
prevent the engine's lifting sideways on the boat transom when the opera-
tor changes direction from forward to reverse driving positions. Installa-
tion instructions for this kit are given below.
Figure 1
Figure 2
INSTALLATION INSTRUCTIONS FOR #380608 TRANSOM PLATE KIT.
1. Position motor at center of the transom (normal position).
2. Insert transom plate under clamp screw as shown in Figure 2 and
tighten clamp screw.
3. Tilt motor forward and hold stern bracket clamp in position as
shown in Figure 3.
4. Using clamp as a template, mark transom for drilling mounting screw
holes.
5. With a pencil, outline transom plate on transom.
6. Remove motor from transom.
7. Place transom plate accurately within outline made in step 5 and mark
transom for installing mounting screws, using transom plate as a tem-
plate.
-over-


