Back to previous page

Evinrude Powerhead Bulletin #1015 - Assuring Full Throttle Advance

Issued in July 1973, this factory bulletin explains how to correct restricted throttle advance on 1973 Evinrude 85, 115 and 135 HP V-4 outboards by modifying the spark advance lever boss.

1973 Evinrude Service Department letterhead1973 Evinrude Service Bulletin letterhead
POWERHEAD #1015
July, 1973
ASSURING FULL THROTTLE ADVANCE
1973, 85 THRU 135 H.P. MODELS
Recently we have had field complaints of some 1973 V4 engines not being able to obtain full throttle advance. This is caused by the boss on the P/N 318561 spark advance lever being too high. The arrows on the photo indicate the original part and one which has been modified.
Original spark advance lever before modificationModified spark advance lever after boss reduction
Original
Modified

To correct the problem, we recommend removal and disassembly of the spark advance lever. Since the piece is spring loaded, caution should be exercised. See 1973 85-135 h.p. parts catalog page 16.

Remove the spark lever bushing P/N 318560, then file or grind the boss approximately one half of its original height. Enough of the boss must be left to allow engagement of the throttle lever spring.

The improved spark advance lever is on motors built after the following model and serial numbers.

85383-02825
115383-03100
135383-02225
EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Inductive Ignition Timing Light & Feeler Gauge Set

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 318561

Search for original or compatible replacement part 318561. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.