← Back to 1970s OMC service bulletins

Evinrude Powerhead Service Bulletin #1022 - Engine Starting Speed

Issued September 1973, this factory bulletin describes a starting-speed safety change on 1974 Evinrude 50-135 HP outboards. It explains the removal of the speed limiting switch and illustrates the recommended throttle cam position when starting an engine without the remote control connected.

Evinrude Service Bulletin factory header
POWERHEAD #1022
September, 1973
ENGINE STARTING SPEED ON ALL 1974 50-135 HP MODELS
Factory illustration of throttle cam and cam roller, 50 through 135 HP V-4 shownSafety warning triangle
SAFETY WARNING
Beginning with the 1974 models, thespeed limiting switch (safety switch)has been removed from the powerhead.The engines maximum RPM whilestarting will be limited by the warm-uplever on the remote control. If theengine is being operated without havingthe control hooked up, you should usecare to determine what the throttle
setting is since it would be possible to start the engine at wide open throttle. Toprotect against this possibility, we recommend that, before starting the engine, youalign the cam follower roller with the "start" mark on the throttle cam.See illustration.
EVINRUDE MOTORS
Service Department