← Back to 1970-1980 OMC service bulletins

Evinrude Electrical Bulletin #1028 - Protective Sleeve for Electrical Leads

Issued November 1973 for 1974 40 H.P. outboards, this bulletin describes a clamp clearance issue that could damage ignition wiring. Evinrude directed dealers to bend the clamp back and protect the leads with spiral wrapping on affected engines.

Original 1973 Evinrude Service Department letterhead
Original Service Bulletin banner
ELECTRICAL #1028
November, 1973
PROTECTIVE SLEEVE TO ELECTRICAL LEADS FOR 1974 40 H.P.
We have found several instances where the upper clamp by the by-pass cover has not been properly bent. When this occurs, there is a possibility that one or more of the electrical leads coming from the armature plate may rub against the upper ignition coil as the armature plate is advanced or retarded. See Figure 1. If this rubbing continues over a long period of time, the insulation could be worn off the leads causing one of the electrical components to short out. We are now insuring that all clamps are properly bent. In addition, we are also encasing these leads in a spiral wrapping. See Figure 2.
Figure 1: clamp not bent, possible rubbing point
Figure 2: clamp bent back, spiral wrapping installed
40404 - 1387
40405 - 1361
40454 - 1200
40455 - 1558
Motors manufactured before the above serial number are to have a spiral wrapping added and if necessary bend the clamp down as shown in Figure 2. This should be done on all engines in stock. If the engine(s) have been delivered to the customer, add the spiral wrapping and bend the clamp when the engine is first brought in for service.
A spiral wrapping and list of engine model and serial numbers is being mailed to each selling dealer. Should you find a unit that requires a spiral wrapping contact the Evinrude Service Department as this item can not be purchased separately from your parts distributor.
EVINRUDE MOTORS
Service Department