← Back to 1970s OMC service bulletins

Evinrude Fuel System Service Bulletin #1029 - Low Speed Knob Grommet

Issued November 1973, this factory bulletin addresses a low-speed adjustment knob grommet that can become dislodged and restrict carburetor airflow on 1974 Evinrude 9.9 and 15 HP outboards. It identifies the two grommet locations and explains how to prevent the grommet from falling into the air silencer.

Evinrude Service Bulletin factory header
FUEL SYSTEM #1029
November, 1973
LOW SPEED KNOB GROMMET RESTRICTING AIR FLOW
ON 1974, 9.9 AND 15 HP MODELS
Evinrude Motors Service Department has received a few reports of the slow
speed knob grommet coming loose and being pulled into the carburetor venturi
opening or in some cases all the way through to the leaf plate. This will result
in hard starting or no start or premature spark plug fouling.
There are two identical grommets around the slow speed adjusting knob; one
in the lower motor cover, the other in the air silencer. Remove the upper
motor cover and look between the lower motor cover and the air silencer to be
sure both grommets are in place.
Use caution when removing and installing the slow speed adjusting knob to
prevent dislodging the slow speed knob grommet which can fall into the air
silencer cavity.
EVINRUDE MOTORS
Service Department