Back to 1970-1980 OMC service bulletins

Evinrude Powerhead Bulletin #1031 - Moving Cable Clamp on 1973-74 50 HP Models

January 1974 factory instruction to relocate a motor cable clamp away from the tilt handle screw, preventing damage to the cable insulation and electrical shorts.

Evinrude service bulletin factory header
POWERHEAD #1031
January, 1974
MOVING CABLE CLAMP ON 1973-74 50 H.P. MODEL

We recently relocated one of the clamps which hold the motor cable to the upper high voltage coil. This was done to provide additional clearance between the tilt handle screw and the motor cable since it is possible, in some cases, for this screw to damage the motor cable insulation and short out the cable.

Please check any 1973-74 50 H.P. engines which you have in stock or which your customers bring in for service. If not already done, the clamp should be relocated as shown in the illustration.

Factory photograph showing clamp originally here and move clamp to here
EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Outboard Ignition Spark Tester & Digital Multimeter

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.