← Back to 1970s OMC service bulletins

Evinrude Lower Unit Bulletin #1042 - Checking the Angle Adjusting Thrust Rod

Issued April 1974, this Evinrude service bulletin instructs mechanics to inspect the angle adjusting thrust rod after an outboard gearcase strikes an underwater object. It explains how a bent rod can affect reverse-lock release forces, potentially damaging the stern bracket or allowing the engine to climb out of the water in reverse.

Evinrude Service Bulletin factory header
LOWER UNIT #1042
April, 1974
CHECKING THE ANGLE ADJUSTING THRUST ROD
ON ALL OUTBOARD MODELS
NOTE
If, when servicing an engine, you are aware that the gearcase has struck
an underwater object, you should always make a point of checking for a
bent thrust rod. Oftentimes, this is the only visible sign of damage.
A bent thrust rod will increase the breakaway force required to release
the reverse lock when the engine is being operated in forward gear. If
the engine were to strike another underwater object, the breakaway force
required may be so high that the force of the impact may cause the stern
bracket to crack or break before the reverse lock releases.
A second affect a bent thrust rod can have is to reduce the force required
to release the reverse lock when the engine is being operated in reverse
gear. Under these conditions, the reverse lock may release when the
engine is accelerated in reverse, causing the engine to climb out of the
water.
EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Lower Unit Gear Oil Pump & Seal Puller Tool

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.