Back to 1970-1980 OMC service bulletins

Evinrude Powerhead Bulletin #1048 - Water in Cylinders of 1971-1974 50 HP Models

Issued May 1974, this Evinrude service bulletin describes water intrusion associated with incorrectly sized or warped exhaust covers on 1971-1974 50 HP outboards. It provides inspection instructions and identifies an additional gasket for oversized covers.

Evinrude Service Bulletin factory header
POWERHEAD #1048
May, 1974
WATER IN CYLINDERS OF 1971-1974 50 HP MODELS

We recently learned that some inner & outer exhaust covers were not made to specifications. These parts are thicker than normal so that the inner cover may contact the outer cover when installed. If this occurs and goes unnoticed, the inner cover will be warped allowing water leakage into the exhaust area.

Whenever a 50 HP engine is being serviced and the problem is diagnosed as water in the cylinders, the exhaust covers should be checked for warpage or for being oversize. Covers suspected of being warped can be checked with a steel straight edge or on a surface plate. If the cover is found to be warped it must be replaced.

A quick visual check for oversize covers can be made by placing the two covers together without a gasket. If the covers are oversize, the exhaust passages of the inner cover will touch the outer cover so that the gasket surfaces cannot contact each other. Parts which are found to be oversize can be used if an extra gasket (P/N 315868) is placed between the covers.

EVINRUDE MOTORS
Service Department