Back to 1970s OMC bulletins

Evinrude Bulletin #1053 - Tilt-Assist Shock Absorbers

August 1974 factory service tips for 1975 Evinrude 70, 75, 85, 115 and 135 H.P. outboards. Includes the pressurized and non-pressurized shock absorber identification chart, mounting precautions and tilt-assist service guidance.

Evinrude Service Bulletin letterhead
ENGINE MOUNTING #1053
August, 1974
SERVICE TIPS - TILT-ASSIST SHOCK ABSORBERS
FOR MODELS 70573, 75543, 85593, 115593, 135543 & 135583

Beginning with the 1975 model year, the engines listed above will be equipped with pressurized shock absorbers which greatly ease the physical effort required to tilt the engine. Listed below is some general information which should be kept in mind when mounting one of these engines or when servicing the shock absorber.

1.

The engines tilt lock lever should be in the "run" position whenever the engine is lifted by the lifting eye. If the lever is in the "tilt" position, the stern bracket will swing out making it difficult to install the engine on a boat or motor stand.

2.

The shock absorbers are sealed and cannot be repaired or re-pressurized. A loss of pressure will not affect the shock absorbing function as long as the oil is not lost. It will only affect the ease with which the engine can be tilted.

3.

There are two pressurized and one non-pressurized shock absorbers in use on 1975 engines. These are similar in appearance but can be identified as follows:

PART NO.USED ONIDENTIFICATIONREMARKS
38675570573, 75543Stamped with P/N 386755. 1" wide green paint band.Pressurized
38675685593, 115593,
135543, 135583
Stamped with P/N 386756. 1" wide red paint band.Pressurized
385532135589Stamped with P/N 385532. No paint band.Non-pressurized
4.

If a customer wishes to reduce or eliminate the tilt-assist feature, one or two of the non-pressurized shock absorbers (P/N 385532) can be installed. On V-4 engines, the amount of tilt-assist can also be reduced by installing shock absorbers from the 70/75 h.p. Under no circumstances should V-4 shock absorbers be installed on 70/75 h.p. engines since this would increase the amount of tilt assist to the point where the engine might not return to water after impact with a submerged object.

EVINRUDE MOTORS
Service Department