Back to previous page

EV-1060 - Correct Propeller Thrust Bushing

October 1974 Evinrude Lower Unit Bulletin #1060 explains which propeller thrust bushings fit 1975 50, 75, and V-4 outboards and warns of gearcase damage from incorrect installation.

Evinrude Service Bulletin factory header
LOWER UNIT #1060
October, 1974
USING CORRECT PROPELLER THRUST BUSHING ON 1975 50-135 HP MODELS
NOTE:
The propeller attaching hardware supplied in the owner's kit of 1975 50 and 75 H.P. (short) engines is the same as that supplied with 1975 70, 75 (long) and V-4 engines except for the thrust bushing. The larger thrust bushing supplied with 70, 75 (long) and V-4 engines will fit on the 50 and 75 H.P. (short) propeller shaft and it is possible to install the propeller. However, this must not be done since the larger thrust bushing would be jammed against the gearcase head and damage to the gearcase head will occur as soon as engine is run in gear.
Dimensioned drawings comparing thrust bushings 318841 and 320305
The schematic is included to aid you in identifying these thrust bushings.
EVINRUDE MOTORS Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Propeller Wrench & Marine Spline / Triple-Guard Grease

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.