Back to previous page

EV-1063 - Cam - Point Timing

November 1974 Evinrude Ignition Bulletin #1063 explains point timing cam geometry on 1974-1975 9.9, 15, and 40 HP engines, including Quik-Rise Magneto ignition.

Evinrude Service Bulletin factory header
IGNITION #1063
November, 1974
CAM - POINT TIMING FOR 9.9, 15, AND 40 H.P. MODELS
The point timing on the 1974 and 1975 9.9, 15 and 40 H.P. engines have a high point on the cam which is only 10° wide. On the P/N #318929 cam the set mark is cast on the top as shown in figure (1). The points must reach their widest point within the 10° of the set mark. The crankshaft of the 40 H.P. has the cam ground on it and there is no marking to show the 10° area where the points are fully opened. Use special care if you use a feeler gauge to set points on the 9.9, 15 or 40 H.P. engines with Quik-Rise Magneto ignition.
Figures 1 and 2 showing ten-degree and forty-six-degree point timing cam arcs
Figure (2) shows the type of cam which is used on many of our engines that do not have Quik-Rise Magneto ignition systems. The points remain open for approximately 46°, therefore, point adjustment is much easier on these engines. Keep this information in mind when servicing engines through 40 horsepower.
EVINRUDE MOTORS Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Inductive Ignition Timing Light & Feeler Gauge Set

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 318929

Search for original or compatible replacement part 318929. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.