Evinrude Service Bulletin #1073: New Style Impeller Housings for 50-135 HP Models
Issued March, 1975, this original Evinrude factory bulletin addresses new style impeller housings for 50-135 hp models.

LOWER UNIT #1073
March, 1975
NEW STYLE IMPELLER HOUSINGS FOR 50-135 HP MODELS
We are in the process of switching from aluminum impeller housings to plastic housings with stainless steel liners. The stainless steel liners provide improved housing durability while at the same time allowing lower cost repair parts when service becomes necessary.
Engines equipped with plastic impeller housings should never be run out of water; not even for a few seconds. The frictional heat resulting from a dry impeller rubbing on the liner can cause permanent damage to the housing. A caution transfer is on the lower motor cover near the fuel connector to remind you of this. Make sure the transfer remains on the engine and that the customer is familiar with it.
You will be seeing the plastic impeller housings on 50 H.P. engines first. As you can see from the illustration, they are similar in appearance and construction to the chrome pump kits we have offered for the last few years.
| REF. NO. | PART NO. | NAME OF PART | QTY. PER ASSY. |
|---|---|---|---|
| • | 387216 | WATER PUMP KIT - 50 H.P. | 1 |
| 1 | 303059 | “O” RING, Drive shaft | 1 |
| 2 | 320776 | PLATE, Liner | 1 |
| 3 | 320775 | LINER, Impeller housing | 1 |
| 4 | 315788 | SEAL, Impeller housing | 1 |
| 5 | 315837 | GROMMET, Water tube | 1 |
| 6 | 320777 | TRANSFER, Caution | 1 |
| 7 | 316357 | SCREW, Imp. hsg., short | 2 |
| 8 | 320981 | PLATE, Impeller housing | 1 |
| 9 | 377230 | IMPELLER ASSY. | 1 |
| 10 | 384087 | IMPELLER HOUSING ASSY. | 1 |
| 11 | 315748 | GROMMET, Exh. to housing | 1 |
| 12 | 316658 | SCREW, Imp. hsg., long | 2 |
| • | 308928 | KEY, Impeller | 1 |

EVINRUDE MOTORS
Service Department
Service Department