Evinrude Service Bulletin #1099 (September 1975)

1975 Evinrude service bulletin covering oil-water emulsion at the gearcase drain on 1974-1975 9.9 and 15 HP outboards. The procedure checks the exhaust housing water level, seals and impeller housing bleed hole.

Evinrude Service Bulletin header
LOWER UNIT #1099
September, 1975
OIL-WATER EMULSION DRAINING FROM GEARCASE OF 1974-1975 9.9 & 15 HP MODELS
We have received several reports of customer complaints of an oil-water emulsion draining from the small drain hole in the forward part of the gearcase. Usually these reports indicate the engine was being used extensively at very low speeds. We have found that the problem is a result of a lower than normal water level in the wall-of-water within the exhaust housing and can be corrected as follows:

1) Operate the engine in the test tank until completely warmed-up. Lower the water level in the test tank to the underside of the cavitation plate. At idle speed, water should be coming out of the dump water holes. See Figure 1. If no water is coming out of the holes (exhaust only), this indicates a low water level in the wall-of-water. This is most likely caused by a leaking seal at the bottom of the inner exhaust tube. Replace this seal if necessary.

2) If a variable depth test tank is not available, with the engine on a motor stand, remove one of the bottom screws from either upper mount. Using a small tube, fill the outer exhaust housing with water until water runs out of the dump water holes. Water will also come out of the drain hole in the front of the gearcase. If any water comes out of the propeller hub, the seal at the bottom of the inner exhaust tube is bad and should be replaced. If water comes out from the lower mount area the seal between the water pump and exhaust housing is bad and must be replaced.

Figure 1, cutaway of lower unit showing exhaust housing, seal and dump water holes
Figure 1
BULLETIN #1099

3) With gearcase removed, check the position of driveshaft in impeller housing seal. It should be centered. If it is not, leakage here could result in lower than normal water level in the wall-of-water.

4) Remove the impeller housing and enlarge the bleed hole from 1/16" to 11/64". See Figure 2. During reassembly, make sure driveshaft is centered in impeller housing seal (see item 3 above).

Figure 2, impeller housing bleed hole to enlarge
Figure 2
EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

NMMA TC-W3 2-Stroke Marine Outboard Oil & Oil Mixing Ratio Bottle

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.