Back to 1970s OMC service bulletins

Evinrude Powerhead Bulletin #1106

1976 70 and 75 HP powerhead improvements, including pistons, wrist pins, connecting rods, and replacement part numbers.

Evinrude factory service bulletin header
POWERHEAD #1106
November, 1975
1976 70 & 75 H.P. PRODUCT IMPROVEMENTS

Among the many improvements in our 1976 model line are three which affect the 3 cylinder engine:

PISTONS. Changes on the pistons include lowering the rings 1/8” and increasing the inside dome thickness. These changes place the rings in a cooler heat zone which improves the heat transfer through the rings, resulting in improved ring and land life.

WRIST PINS. The wrist pin diameter has been increased from 5/8” to 3/4”. This change distributes the load over a greater area on the wrist pin, which in turn reduces the likelihood of the wrist pin pounding out.

CONNECTING RODS. The connecting rods have been redesigned so that the loads at the crankpin end will be spread over a greater number of rollers. This change will result in longer bearing life due to the decreased loads.

If you have customers whose severe use applications have resulted in failures in the areas mentioned above, changing over to these new parts should eliminate future failures. These new parts can be installed as a set on any 1974 70 H.P. or 1975 70/75 H.P. engine. The part numbers of these new items are:

PART
NUMBER
DESCRIPTIONQUANTITY
REQ’D
387284Piston Assy. - Std.3
387285Piston Assy. - .020” O.S.3
387286Piston Assy. - .030” O.S.3
320954Wrist Pin3
317831Retaining Ring - Wrist Pin6
385482Needle Bearing Assy. - Wrist Pin3
387283Connecting Rod3

(Ring sets are the same as shown in your 1974-75 Parts Catalog)

All of these parts are available through your parts distributor.

EVINRUDE MOTORS
Service Department