Back to Evinrude bulletins

Evinrude Bulletin #1119: Possible Interference in Steering System

March 1976 safety bulletin for 1976 Evinrude 35 HP thru-the-pivot steering systems, describing interference between a steering connector bolt and the stern brackets.

Evinrude Service Bulletin header
CONTROLS #1119
March, 1976
POSSIBLE INTERFERENCE IN STEERING SYSTEM ON
1976 35 H.P. WITH THRU-THE-PIVOT STEERING
⚠ SAFETY WARNING
It has come to our attention that some steering connector kits for 35 H.P. outboards can have an interference condition between the stern brackets and the head of the steering connector bolt. See illustration. In an extremely tight turn, it is possible to apply enough force to the steering wheel to unknowingly force the head of the screw past the end of the stern bracket. If this occurs, the operator will not be able to readily return the engine to center creating a potentially dangerous situation.
Original factory illustration 1
If you install a steering connector kit other than OMC, check for adequate clearance between the screw head and both stern brackets with the thrust rod in the rearmost hole. This check should be made at every installation since clearance will vary depending on installation technique. If interference is found, the outside corners of the stern brackets should be filed to provide adequate clearance.
EVINRUDE MOTORS
Service Department