Back to Evinrude bulletins

Evinrude Bulletin #1120: Change in High Tension Lead Location

March 1976 ignition bulletin showing the original and revised high tension lead clamp routing for 1969-1976 Evinrude 4 HP outboards, including tie strap P/N 320107.

Evinrude Service Bulletin header
IGNITION #1120
March, 1976
CHANGE IN HIGH TENSION LEAD LOCATION FOR ALL 1969 THRU 1976 4 H.P.
We recently changed the location of the high tension lead clamp on 4 H.P. outboards from that shown in Figure 1 to the location shown in Figure 2.
Original factory illustration 1
Original factory illustration 2
In addition, we are securing the high tension leads to the fuel pump mounting boss using a P/N 320107 Tie Strap. See Figure 3. These changes reduce the possibility of the high tension leads getting caught on the motor cover hood during cover removal.
We recommend you perform this modification whenever you have a 4 H.P. engine in for service.
Original factory illustration 3
EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Outboard Ignition Spark Tester & Digital Multimeter

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 320107

Search for original or compatible replacement part 320107. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.