Evinrude Ignition Bulletin #1129 - Hard Starting or Erratic Ignition

May 1976 factory instructions for correcting hard starting or erratic ignition on 1969 and 1970 Evinrude 115 HP V-4 outboards, including pulse pack, rotor, lead assembly and clipper circuit changes.

Evinrude Service Bulletin
IGNITION #1129
May, 1976
HARD STARTING OR ERRATIC IGNITION ON 1969 & 1970 115 H.P.

On the 1969 and 1970 V-4 engines with service replacement pulse pack part number 385038 and the ignition safety circuit, there have been engines that would not start or run correctly. When an engine comes in that does not start or run correctly, we suggest making the following modifications:

Install a part number 384522 phase II pulse pack with sensor rotor part number 316678. Remove the sensor leads from the base plate assembly and install part number 385200 lead assembly on the original base plate assembly. Follow the instructions included with the new lead assembly. Put the ground lead toward the clamp so that the sensor leads are within the channel for protection, as shown in figure 1.

Remove and discard the ignition safety circuit. Install a clipper circuit part number 580891. Refer to 1972 125 hp engine service manual for installation instructions. Check engine timing with timing light. These modifications result in an engine with the ignition system similar to the 1972 125 hp models.

Figure 2 shows the 1972 distributor base plate assembly on the right and the 1969 & 1970 distributor base plate on the left with lead assembly part number 385200.

Figure 1 sensor lead assemblyFigure 2 distributor base plate assemblies
Figure 1
Figure 2
EVINRUDE MOTORS
Service Department