Evinrude Powerhead Bulletin #1131 - Retorquing Cylinder Head Bolts

June 1976 factory bulletin explaining the need to retorque cylinder head bolts on Evinrude 2 through 200 HP outboards to prevent water entering the cylinders.

Evinrude Service Bulletin
POWERHEAD #1131
June, 1976
RETORQUING OF CYLINDER HEAD BOLTS ON ALL 2 THRU 200 HP MODELS

We continue to receive reports of new engine failure due to water entering the cylinders. This condition is usually caused by low cylinder head bolt torque.

On Service Bulletin Powerhead #1114 we recommended retorquing the cylinder head bolts before the outboard is delivered to the customer. This procedure should still be followed on every new engine since cylinder heads often lose torque after factory test and initial storage. Some gasket material may also be more sensitive to high temperature.

When retorquing the cylinder head bolts, always follow the recommended torque values and sequence of torquing illustrated in your service manual.

EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Cylinder Hone Tool, Piston Ring Compressor & Digital Bore Caliper

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.