Evinrude Service Bulletin #1142: 40 HP Crankshaft Appearance

September 1976 bulletin documenting acceptable surface finishes on the shot-peened crankshaft, part 311356, used on 1970-1973 40 HP outboards.

Evinrude Service Bulletin shared factory letterhead
POWERHEAD #1142
September, 1976

40 HP CRANKSHAFT APPEARANCE

In 1972 a shot peening process was incorporated in the manufacturing of the #311356 crankshaft, used on 1970 - 1973 40 H.P. outboards. The treatment, used on the upper crankshaft throw, primarily in the upper journal-to-upper-thrust-face radius, improves the fatigue life of the crankshaft for longer service.

Due to routing changes in the manufacturing process there are crankshafts with several appearance differences.

  1. Crankshafts that were shot peened last may have a dull finish over the entire upper journal and upper thrust face. See Figure 1.
  2. Crankshafts shot peened last, with a mask over the journal lower half, have a dull finish only on the journal upper half and upper thrust face. See Figure 2.
  3. Crankshafts with a final lapping operation after shot peening have a dull finish only in the upper radius and upper thrust surface. See Figure 3.

All three varieties of the crankshaft have the essential shot peening treatment for improved fatigue life whether apparent, Figures 1 & 2, or not so apparent, Figure 3.

Figures 1 through 3: Three acceptable crankshaft surface finishes

EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Permatex Aviation Form-A-Gasket Sealant & Gasket Scraper

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 311356

Search for original or compatible replacement part 311356. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.