Evinrude Service Bulletin #1145: 140 H.P. Motors on Bass Boats

Issued January 1977, this bulletin explains propeller ventilation on high-transom bass boats and the factory recommendation for double-cupping SST propellers.

LOWER UNIT AND PROPELLER #1145
January, 1977

Subject:   140 H.P. Motors on Bass Boats

There have been reports of propeller ventilation with 140 H.P. motors on high transom bass boats, when trimming out for maximum speed.

Ventilation occurs if the motor is too high on the transom and can usually be corrected by lowering the motor one transom mounting hole. If the motor cannot be lowered, the problem can often be corrected by adding more cup to the propeller.

We recommend having your local propeller shop “double cup” SST propellers as illustrated in figure.

Note: Adding cup has the effect of increasing propeller pitch, so it may be necessary to drop one pitch when adding cup, i.e. a 19 inch SST with added cup allows engine RPM approximately equal to a standard 21 inch SST.

Do not attempt to cup aluminum propellers as they may crack.

Motor height and trim can be very critical on high performance hulls, which include many bass boats. As little as 1/2 inch change in a motor height can result in a measurable speed increase with proper trim.

Excessive height or trim will result in propeller ventilation, a large rooster tail, exhaust noise, and a marked loss of boat speed.

EVINRUDE MOTORS
Service Department
Factory illustration showing the double-cup area on the trailing edge of an SST propeller blade, 3/16-inch cup, and blend-to-original-shape guidance
May be scaled for 19”, 21” and 23” SST propellers