Evinrude Accessories Service Bulletin #1159 (July 1977)

This factory bulletin addresses the inspection of ignition shut off device P/N 172886 and replacement of an ignition switch face plate that could prevent the key from turning fully to OFF in an emergency. It applies to certain Johnson and Evinrude outboards and OMC stern drives.

Evinrude service bulletin header
ACCESSORIES #1159
July, 1977

SUBJECT: PART NUMBER 172886 ACCESSORY IGNITION SHUT OFF DEVICE

△ SAFETY WARNING

CAN BE FOUND ON MODELS:

1.   1973-76 Johnson or Evinrude Outboards equipped
     with Command Center or Power Pilot Single Lever
     Remote Controls.

2.   Outboards equipped with Remote Electric Starting Kits.

3.   OMC Stern Drives which have Plastic Threaded
     Ignition Switches.

The tang (flange) on the face plate part number 122800 (see figure 1) provides greater assurance that the ignition key will be turned to the “OFF” position in an emergency, particularly should the key be loose in the lock due to corrosion, over or under lubrication, or any other cause.

Figure 1, ignition shut off device and face plate

Because this part is designed to assist in shutting the engine off in certain emergency situations, it is extremely important that the boat owner be certain that this part is properly maintained and that the part is in good operating condition.

As an aid to the boat owner in this responsibility in this regard, any personnel of yours performing service of any kind on any boats carrying this part, should inspect this part to check that it is in good operating order. Further, any new employee which you hire should be instructed in this procedure.

(over)

To be certain that there has been no damage to the unit from any cause (i.e., from the tang (flange) being bent or missing due to any outside force or any other cause) when you make your inspection, remove the present face plate and insert a new face plate Part No. 123435 (even if there is no damage to the part that is apparent to the eye).

Replacement face plate P/N 123435, square hole and tang

As an aid to you in fulfilling your responsibility to your customers and as an incentive to inspect all units that come into your dealership, OMC will issue a credit voucher for a new Face Plate Part 123435 plus allow $7.50 for labor and handling.

Please fill out an Evinrude, Johnson, OMC Stern Drive or OMC Parts & Accessories warranty claim form for each unit reworked and submit to:

OMC Parts & Accessories
ATTENTION: SERVICE DEPARTMENT
3225 Prairie Drive - R.R. #5
Beloit, Wisconsin 53511

All claims must include model and serial number of the engine, and the owner's name, address and signature. All removed Face Plates No. 122800 must accompany warranty claims.

EVINRUDE MOTORS
Service Department