Back to 1970-1980 OMC service bulletins

Evinrude Powerhead Bulletin #1175 - 9.9 and 15 H.P. Piston Rings

Issued January 1978, this Evinrude service bulletin explains how to inspect piston rings P/N 386279 and 386280 for incorrect machining before installation, preventing potential piston and cylinder damage.

Evinrude Service Bulletin factory letterhead
POWERHEAD #1175
January, 1978
SUBJECT: 9.9 AND 15 H.P. PISTON RINGS, P/N 386279 AND 386280

When installing new piston rings in a 9.9 or 15 H.P. motor, be sure that the piston rings are capable of fitting into the ring groove so that the piston ring is flush to or below the surface of the piston. It has been reported that some piston rings were incorrectly machined so that they could not properly fit into the ring grooves. When installed, these piston rings can protrude above the surface of the piston. While the piston can be installed in the cylinder with the incorrectly machined piston rings, the pistons and cylinders could be damaged within a short period of operation.

To check the piston rings for correct machining, insert the piston ring into the ring groove. Lay a straight edge along the side of the piston as shown in Figure 1 and 2. Check several places around the circumference of the piston. A correctly machined piston ring will fit as shown in Figure 1. An incorrect ring will fit as shown in Figure 2.

If you find piston rings that are machined incorrectly, return them to your Parts Distributor for replacement.

Factory Figures 1 and 2 comparing properly machined piston ring below piston surface against improperly machined ring protruding above piston surface
EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Cylinder Hone Tool, Piston Ring Compressor & Digital Bore Caliper

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 386279

Search for original or compatible replacement part 386279. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.