← Back to 1970-1980 OMC service bulletins

Evinrude Powerhead Bulletin #1176 - Cylinder Reboring and Repair

Issued February 1978, this Evinrude factory bulletin identifies a cylinder-reboring facility, gives instructions for preparing and shipping cylinder blocks, and lists the period charge of $12.50 per hole. It replaces Powerhead Bulletin #1074.

Evinrude Service Bulletin factory letterhead
POWERHEAD #1176
February, 1978
CYLINDER REBORING AND REPAIR

Complete Cylinder Reboring facilities are available at:

RIVERSIDE MARINE SUPPLY
1900 CANTRELL ROAD
LITTLE ROCK, ARKANSAS  72202

PHONE: (501) 372 - 0985
ATTEN: MR. PAT BOOTH

Before returning the cylinder block be sure it is cleaned and
stripped of all studs, covers, heads, etc.  Specify the over-
size rebore, (i.e. .020, .030, etc.) required.  Oversize pistons
are listed in the Parts Catalogs.

Remember to package the cylinder carefully to prevent damage
during shipment.

The cost of reboring is $12.50 per hole for all outboards.

EVINRUDE MOTORS
SERVICE DEPARTMENT
NOTE:  This bulletin replace Powerhead # 1074.