← Back to previous page

Evinrude Accessories Bulletin #1177 - Hydraulic Tilt & Trim Pump Check Valve Repair Kit

Issued February 1978, this bulletin addresses saltwater corrosion in the hydraulic tilt and trim pump check valve and specifies replacement kit P/N 173569 and protective Neoprene Dip P/N 909570.

Evinrude Service Bulletin factory letterhead
ACCESSORIES #1177
February, 1978
SUBJECT: HYDRAULIC TILT & TRIM
PUMP CHECK VALVE REPAIR KIT 173569

In regard to Hydraulic Tilt & Trim Pump, P/N 172655, Prestolite No. HYB-5001, we have experienced some corrosion to the check valve in the valve body, due to inadequate protection for saltwater areas.

There is now a repair kit, P/N 173569, available to replace these check valves.

Remove the snap ring and run the pump, the oil pressure will push the valve out.  If the valve does not come out, run the pump in the other direction.

After installing new valve and snap ring, apply a coat of Neoprene Dip, P/N 909570, making sure to cover the snap ring completely.

EVINRUDE MOTORS
Service Department