Back to 1970-1980 OMC service bulletins

Evinrude Ignition Bulletin #1179 - Ignition Coil Internal Changes

March 1978 factory instructions for identifying improved ignition-coil windings and selecting the correct ignition tester specifications. Covers five coil part numbers used on 1968-1971 Evinrude outboards.

Evinrude Service Bulletin factory header
IGNITION #1179
March, 1978
SUBJECT: IGNITION COIL INTERNAL CHANGES
          P/N'S 580688, 580730, 580740, 580847, 580833
MODELS AFFECTED:   580688 - 1968 65 HP,   580730 - 1970 115 HP,
HIGH PERFORMANCE V-4,
580740 - 1970-72 85, 100, 115, 125 HP
580833 - 1971-73 50 HP & 580847 - 1970-71 60 HP

To improve their performance, a change has been made in the windings of the coils listed above.

We do not feel that the change was drastic enough to require a change in part number; however, we feel a need to inform you how you can determine whether the coils you have in stock are of the former windings or whether they are the improved windings. To check this, measure the resistance between the blue primary lead and the high tension (secondary) lead. If you get a reading of 1300 ± 200 ohms, it is the improved winding. If you get a reading of 1900 ohms, it is the former winding.

If your coils have the new windings, use the test specifications listed below.

IGNITION COIL TEST
SPECIFICATIONS

Stevens Model ST-75
Reverse Polarity (Switch Setting CD)1.9
Stevens Tester Model M.A. -75 or M.A. -80
Switch
**A
Index Adjustment
20
**Use Model CD-1 Adaptor
Red test clip to orange/black
Black test clip to orange
Merc-O-Tronic with Capacitor Discharge Adapter
Model 55-980
Operating Amperage
Min. - Max.
Primary Resistance
Min. - Max.
Secondary Continuity
Min. - Max.
1.9.1 Ohm8 - 20

Graham Tester Model 51

Maximum Secondary3,000 ohms
Maximum Primary0.6 ohm
Coil Index50
Coil Test Minimum AMPLIFIED27
(With secondary circuit “open”
Hi tension lead disconnected)
Gap Index50 (Coil must fire spark on tester at this setting)

If you have coils with the old windings follow your normal procedure outlined in the appropriate service manual.

The performance of the motor will be the same with either coil, only the test procedures are affected.

It is absolutely necessary that you follow this procedure so you are not mislead by the readings you receive during your troubleshooting process.

CR78-26
EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Outboard Ignition Spark Tester & Digital Multimeter

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 580688

Search for original or compatible replacement part 580688. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.