Back to 1970-1980 OMC service bulletins

Evinrude Ignition Bulletin #1180 - Good Electrical Connections

March 1978 Evinrude service guidance for diagnosing intermittent electrical faults caused by improperly seated pins and sockets in waterproof connectors. Includes factory seating dimensions and OMC insertion tool P/N 322697.

Evinrude Service Bulletin header
IGNITION #1180
March, 1978
SUBJECT: GOOD ELECTRICAL CONNECTIONS

If you encounter electrical problems on outboard motors and OMC Stern Drives and Sail Drive units, they may be due to poor connections in the water proof connectors. The pins and sockets may be improperly seated in their connector halfs resulting in poor or no connections.

Figure 2 shows the proper dimensions of the pins and sockets seated in their connectors.

Figure 1, factory cross sections showing connector seating depths of 0.515 ± 0.025 inch and 0.125 ± 0.025 inch
To correct, use insert tool (OMC P/N 322697) to insert pins and socket to their proper depth. Use alcohol to lubricate the connector before installing pins or sockets. The alcohol does not leave a residue which could contaminate any part of the connector.
EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Outboard Ignition Spark Tester & Digital Multimeter

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 322697

Search for original or compatible replacement part 322697. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.