← Back to previous page

Evinrude Lower Unit Bulletin #1182 - V-6 Pinion Bearing and Pinion Gear Nut Torque

Issued March 1978 for 1976-1978 V-6 gearcases, this bulletin explains correct tapered pinion-bearing installation and specifies a 60-65 ft-lb pinion gear nut torque to prevent premature bearing and gear damage.

Evinrude Service Bulletin factory letterhead
LOWER UNIT #1182
March, 1978
SUBJECT: V-6 PINION BEARING & PINION GEAR NUT TORQUE SPECIFICATION
MODEL:  1976 - 1978
Incorrect installation of the pinion bearing in the 1976-1978 V-6 gearcase drastically reduces the life of the bearing. The bearing is tapered so that when installed correctly its race compensates for stresses in the gearcase and allows full roller contact. Whenever a gearcase is disassembled the pinion bearing should be checked to insure that it has been installed with the “lettering” up. Check for spalling on the corners of the rollers and replace the bearing if necessary.

The correct torque on the pinion gear nut in the lower gearcase is 60 - 65 ft. lbs. (85-90 Nm). This torque is very important in maintaining long life to the pinion gear.

If the nut is over torqued, too much stress is placed on the pinion gear which may shorten the life of the pinion gear.

If less than 60 ft. lbs. (85 Nm) of torque is applied, a condition known as “fretting” (i.e., metal transfer between the gear and taper, caused by the gear moving on the taper) will shorten the life of the component parts.

Always apply the correct torque to this nut when performing service to the gearcase.

Exploded pinion shaft, pinion bearing and pinion nut illustration
EVINRUDE MOTORS
Service Department
CR78-24

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Bearing Race & Seal Driver Set + Marine Assembly Grease

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.