← Back to 1970-1980 OMC service bulletins

Evinrude Engine Mounting Bulletin #1185 - Motor Pivot Tube

April 1978 safety warning concerning substitute motor tilt tubes, including Teleflex Bulletin 783, and the use of sealing nut P/N 322376 to prevent corrosion.

Evinrude Service Bulletin factory letterhead
ENGINE MOUNTING #1185
April, 1978
Safety warning

“We recently have been advised by Teleflex Marine, PO Box 48, Limerick, Pennsylvania 19468, telephone area code 215-495-7011, through their Service Bulletin #783 of 12/23/77 (see copy) that a dealer substitution of the original motor tilt tube can (in the words of the bulletin) “cause a safety hazard”.

Please review the instructions in this bulletin very carefully, and immediately contact any motor owners or boat owners where you have made any such modification as described in the bulletin.

We also suggest that you notify your own service personnel that all boats coming in for repair or service should be checked to be certain that the modification described has not been made.

Customers experiencing corrosion problems should use our tilt tube sealing nut P/N 322376. This sealing nut prevents moisture from entering inside of the tilt tube and can be used on all outboard models from 35 HP thru V-6 models.

MOTOR PIVOT TUBE
Teleflex Marine service bulletin 783 dated December 23, 1977, reproduced from factory document
EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Bearing Race & Seal Driver Set + Marine Assembly Grease

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 322376

Search for original or compatible replacement part 322376. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.