Evinrude Service Bulletin #1191

Choke Clevis Wear And Loosening Due To Vibration. June, 1978. Factory service information for v-4’s thru 1978.

Evinrude Service Bulletin factory header
FUEL SYSTEM #1191

June, 1978

SUBJECT:   CHOKE CLEVIS WEAR AND LOOSENING DUE TO VIBRATION

MODELS:   V-4’s THRU 1978

You may find that after use some V-4 motors may develop wear at the threaded connection between the choke clevis and the choke solenoid plunger.

To reduce the chance of this condition reoccurring reassembly of a new plastic choke clevis, clean the mating screw threads with OMC Loctite Primer P/N 384884, or equivalent. After final adjustment, as outlined in your Service Manual, apply a small amount of OMC Ultralock P/N 388517, or equivalent, to the top end of the clevis where the solenoid plunger screws into the clevis.

It is recommended that this procedure also be followed with new motors as a part of your pre-delivery servicing.

CR78-47

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Digital Multimeter & Marine Electrical Connector Kit

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 384884

Search for original or compatible replacement part 384884. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.