Evinrude Service Bulletin #1192

25 & 35 H.P. Lower Mount System. June, 1978. Factory service information for 1977 & later 25 h.p. / 1976 & later 35 h.p..

Evinrude Service Bulletin factory header
ENGINE MOUNTING #1192

June, 1978

SUBJECT:   25 & 35 H.P. LOWER MOUNT SYSTEM

MODELS:   1977 & LATER 25 H.P. / 1976 & LATER 35 H.P.

The lower mount assembly on 25 & 35 H.P. motors was changed in mid 1977 to limit the vertical travel of the rubber mounts. Some field reports of mount failures were found to be caused by the motor striking an underwater object or hitting a sandbar. This would generate an upward force deflecting the motor mounts enough to allow the limit stops on the exhaust tube to pass over the limit stops on the steering bracket. In some cases the user noticed excessive motor movement under acceleration before any type of mount failure developed.

The change made in mid 1977 model 25 & 35 H.P. motors incorporates modifications to the lower mount housings, port and starboard, to accept a rubber bumper that acts to limit the vertical movement without affecting isolation.

If you have experienced this type of failure with the earlier model 25 or 35 H.P. motors, you can reduce the risk of such an occurrence by installing the improved parts as follows:

323107 Bumper

323108 Port Side Lower Mount Housing

323109 Starboard Side Lower Mount Housing

For service on modified motors refer to 1977 or later parts catalogue.

CR78-28