Evinrude Service Bulletin #1204

September 1978 Evinrude bulletin identifying special crankshaft seal rings for certain V-4 and V-6 engines.

Evinrude Service Bulletin header
POWERHEAD #1204

September, 1978

SUBJECT: SPECIAL CRANKSHAFT SEAL RINGS

MODEL: V-4 & V-6

There are some V-4 and V-6 crankshafts manufactured that require a larger seal ring than has previously been provided for service. This seal ring carries P/N 324817 and can be identified by its measured width (.1605 - .1610) and is marked with four white stripes. This special seal ring is used on crankshafts identified with the letter ā€œSā€ and one or more numbers stamped on top of the counterweight. (See illustration.) The numbers designate groove numbers where this special seal ring is to be used. For example, S25 indicates that 324817 Seal Ring is used in grooves #2 & #5. The crankshafts can also be identified by yellow dykem on the outside of the ring groove or grooves that are oversize.

Use of the wrong seal ring in these applications will cause the motor to run rough at idle.

Factory technical illustration for bulletin 1204

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Bearing Race & Seal Driver Set + Marine Assembly Grease

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 324817

Search for original or compatible replacement part 324817. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.