Evinrude Service Bulletin #1205: Tilt and Reverse Lock Lever Lock Up

September 1978 factory instructions for correcting a tilt and reverse lock lever that can move beyond the stop boss on certain manually tilted outboards.

SUBJECT: TILT AND REVERSE LOCK LEVER LOCK UP

MODELS: MANUAL TILT 1977 140 H.P. AND 1978 70/75 AND V-4 MODELS

We have reports that the tilt and reverse lock lever has been found to turn beyond the stop boss on the swivel bracket causing the motor to seize in the tilt position. A redesigned swivel bracket will be incorporated in 1979 models to correct this from occurring.

As a field fix for existing motors, we recommend bending the stop on the tilt and reverse lock lever an additional 3/32 of an inch as shown in Figure 1. Clamp the stop end of the lever in a vise and use a large crescent wrench or large vise grip held close to the bend line and bend the lever 3/32 of an inch. This will provide an extra measure of stop without allowing the lever to go beyond the boss on the swivel bracket.

Figure 1: bend stop 3/32 inch on tilt and reverse lock lever and shaft, part numbers 387813 and 390097
EVINRUDE MOTORS
Service Department