Evinrude Starter Bulletin #1208 (November 1978)

Factory instructions for installing starter pawl return spring 325913 on certain early-production 1979 Evinrude 9.9 and 15 HP outboards. Includes affected model and serial-number ranges and four installation photographs.

Evinrude Service Bulletin shared factory header
STARTER #1208
November, 1978

SUBJECT: STARTER PAWL RETURN SPRING P/N 325913

MODELS: 1979 9.9/15 H.P.

A starter pawl return spring was added to the 1979 Evinrude 9.9 and 15 H.P.

Some early production Evinrude models were shipped without this spring installed. The following serial numbers are the engines affected:

ModelBeginning
Serial Number
Ending
Serial Number
1092410011890
1095510011034
1590410011011
1595410011045

If these engines are in your stock or previously sold, please contact your Service Department and request the spring under P/N 325913. .5 hours labor will be paid for this installation.

The following procedure should be followed to install the starter Pawl Return Spring.

1. Spring part number 325913 is shown in Fig. 1.

Figure 1 - starter pawl return spring
Figure 2 - spring inserted into starter lock
2. Compress the spring with two fingers and slide the coil of the spring down through the hole in the starter lock out as shown in Fig. 2.
© OUTBOARD MARINE CORPORATION 1983 ALL RIGHTS RESERVED
3. The spring is shown partially in place in Fig. 3.
4. Spring shown completely in place in Fig. 4.
Figure 3 - spring partially installed
Figure 4 - spring fully installed
EVINRUDE MOTORS
Service Department
CR 78-70