Evinrude Service Bulletin #1211: LOOSE CHOKE BUTTERFLY SCREWS

This January 1979 Evinrude bulletin warns of choke butterfly screw loosening on 50 HP carburetors and discusses engine speed recommendations.

Evinrude Service Bulletin
FUEL SYSTEM #1211

January, 1979

SUBJECT: LOOSE CHOKE BUTTERFLY SCREWS

MODEL: 50 H.P. CARBURETORS

We have received some reports of 50 H.P. carburetors which are loosening the screws of the choke butterfly due to vibration. We have even seen an instance of this vibration being so great that it wears down the butterfly shaft where it fits through the carburetor body.

This vibration is inherent to a two piston engine of a relative low compression with such a large displacement. However, this vibration will only reach the magnitude of causing these type incidents at or over 5500 RPM.

Although recent improvements such as self-locking screws, larger screw heads and better peened screws, have done much to alleviate this condition, may we suggest that when you hear of such an incident occurring to check out the condition of the propeller and the outboard/boat application. We are sure that this will not occur at under 5500 RPM and, as you are well aware, for longevity of the 50 HP we are recommending propping out at 4800 to 5200 RPM.

CR78-74